Products

001 Nipple Drinker is used in the egg houses. 8mm Ø. It meets 304 stainless steel strength standards and has the feature of running up and down with 0,80 ml to 0,90 ml water flow per minute. Pierce an 8,8 mm hole in the tubing and press the nipple inside. Assemble by attentively. Do not disarrange or drop any parts of the Nipple Drinker.

Made of EPDM rubber, 001/1 Gasket of Steel Nipple Drinker is resistant to chemicals and water. Pierce an 8,8 mm hole in the tubing and put the gasket inside first. Assemble by pressing the gasket up into the tubing.

Produced for hens, this unit only runs up and down. 8mm Ø. Conical screwed unit meets 304 stainless steel strength standards. Pierce an 8,8 mm hole in the tubing. You don’t need to open a screw thread cause Steel Nipple will open it by itself. Assemble by screwing from bottom to the up and be careful not to drop the top of the unit. Water flow is between 0,80 ml and 0,90 ml per minute.

Produced for broiler hens, this unit works all round and gives a constant water flow. 10mm Ø. Conical screwed unit meets 304 stainless steel strength standards. Pierce an 8,8 mm hole in the tubing. Assemble by screwing from bottom to the up and do not drop the top of the unit. You don’t need to open a screw thread cause Steel Nipple will open it by itself. Water flow is between 0,70 ml and 0,80 ml per minute. The difference of this unit from Steel Nipple Flex 360° - 005 is that it is hooked from the needle.

Produced for broiler hens, this unit works all round and gives a constant water flow. 10mm Ø. Conical screwed unit meets 304 stainless steel strength standards. Pierce an 8,8 mm hole in the tubing. Assemble by screwing from bottom to the up and do not drop the top of the unit. You don’t need open a screw thread cause Steel Nipple will open it by itself. Water flow is between 0,60 ml and 0,80 ml per minute. The difference of this unit from 005 is that it is hooked from the top.